Used John Deere 336 Small Square Baler, 540 rpm pto, manual tension, 14x18x50' bale size, 74' pick up, bale kicker, 11L-14 tires, 26x12.00-12 gauge wheels Updated: Fri, Jan 8, 2021 12:37 PM Swiderski Equip, Inc. Spare parts for balers John Deere 336: Rings, Bearings, Needles, Fingers, Shafts, Sleeves,Belts, Seals, Housings, Springs, Sprockets, Washer, Tensioner, Guides, Price.
IMPORTANT: Incorrect adjustment can cause knives to lock or shear cap screw to break.
Do not use anchor cap screw and nuts (B) to move lower left angle guide (C). Anchor cap screw and guide can bind and become distorted. Only use the anchor cap screw and nuts to hold clearance after guide adjustment has been made.
John Deere 336 Square Baler Specs
NOTE: A total of six plow cap screw are used to fasten the lower left angle guide (C). Three of the plow cap screw and nuts (A) are used with anchor cap screw. The other three plow cap screw, washers, and nuts (A) fasten directly to the bale case and machine frame.
15. To adjust left angle guide, loosen six nuts (A) and six anchor nuts (B).
16. Pry plungerhead to extreme right side of bale case.
17. Move lower left angle guide (C) towards right until guide contacts plungerhead side roller (D).
John Deere 336 Square Baler
18. Snug rearmost anchor nuts (B) and rearmost plow bolt nut (A). Do not tighten the other anchor nuts and plow cap screw at this time.
A-Plow and Nuts (6 each used)
B-Anchor Bolt Nuts (6 used)
C-Bale Case Left Angle Guide
D-Plungerhead Side Roller